Wing plate

I started work on the fuse wing bed.  I carefully and hopefully accurately drilled 4 pilot holes through the wing into the fuse wing bed.  Then I marked and cut out an aperture which will help with clamping and also be used for access to the rx

I then cut out 9mm ply to roughly match the shape of the bed and aperture

With a bit of sanding it fits snugly into the fuse.  I must say that the finish inside the fuse looks really good.  Not mine. The manufacturers

The ply was then removed and the wings all drilled for the wing bolts and fittings, then the bolt were installed and the terminations were glued in place